- Buy 5 for $547.00 each and save 5%
- Buy 10 for $518.00 each and save 10%
The AB50A200I PWM servo drive is designed to drive brushless and brushed type DC motors at a high switching frequency. A single red/green LED indicates operating status.
The drive is fully protected against over-voltage, under-voltage, over-current, overheating and short-circuits across motor, ground and power leads. Furthermore, the drive can interface with digital controllers or be used stand-alone, and requires only a single unregulated DC power supply. Loop gain, current limit, input gain and offset can be adjusted using 14-turn potentiometers.
The offset adjusting potentiometer can also be used as an on-board input signal for testing purposes. This drive can use quadrature encoder inputs, Hall Sensors, or a tachometer for velocity control.
|Vendor||Advanced Motion Controls|
|Short Description||40-175 VDC Input; 25A continuous / 50A peak | 4.2kW Output @ 175 VDC in|
|Min Input Supply Voltage (VDC)||40|
|Max Input Supply Voltage (VDC)||175|
|Max Continuous Output Current (A)||25|
|Max Peak Output Current (A)||50|
|Motor System||Single Phase (Brushed, Voice Coil, Inductive Load), Three Phase (Brushless)|
|Operating Mode||Current, Hall Velocity, Duty Cycle (Open Loop), Encoder Velocity, Tachometer Velocity|
|Feedback||Tachometer, Incremental Encoder, Hall Effect Sensors|
|Min Operating Temperature (°C)||0|
|Min Operating Temperature (°F)||32|
|Max Operating Temperature (°C)||65|
|Max Operating Temperature (°F)||149|
|Max Rated Power (W)||4156|
Sample image only. Product may differ