- Buy 5 for $727.00 each and save 5%
- Buy 10 for $689.00 each and save 10%
The DZEANTU-040B080 digital servo drive is designed to drive brushed and brushless servomotors from a compact form factor ideal for embedded applications. This fully digital drive operates in torque, velocity, or position mode and employs Space Vector Modulation (SVM), which results in higher bus voltage utilization and reduced heat dissipation compared to traditional PWM.
The drive can be configured for a variety of external command signals. Commands can also be configured using the drive’s built-in Motion Engine, an internal motion controller used with distributed motion applications. In addition to motor control, this drive features dedicated and programmable digital and analog inputs and outputs to enhance interfacing with external controllers and devices
DZEANTU-040B080 drives feature an EtherCAT® interface for network communication using CANopen over EtherCAT (CoE), and USB connectivity for drive configuration and setup.
Drive commissioning is accomplished using DriveWare® 7, available for download at www.a-m-c.com.
All drive and motor parameters are stored in non-volatile memory.
The DZEANTU Series Hardware Installation Manual is available for download at www.a-m-c.com.
The DZEANTU-040B080 also supports ADVANCED Motion Controls exclusive ‘DxM’ technology which allows connectivity of up to 3 DZSANTU drives to a single DZEANTU on an EtherCAT network.
DZSANTU drives receive commands from a DZEANTU over a high-speed communication interface, allowing for up to 4 axes of servo drive control from a single EtherCAT connection.
|Vendor||Advanced Motion Controls|
|Short Description||18-80 VDC Input; 20A continuous / 40A peak | 1.5kW Output @ 80 VDC in|
|Min Input Supply Voltage (VDC)||18|
|Max Input Supply Voltage (VDC)||80|
|Max Continuous Output Current (A)||20|
|Max Peak Output Current (A)||40|
|Motor System||Single Phase (Brushed, Voice Coil, Inductive Load), Three Phase (Brushless), Closed Loop Vector|
|Operating Mode||Profile Current, Profile Velocity, Profile Position, Cyclic Synchronous Current, Cyclic Synchronous Velocity, Cyclic Synchronous Position|
|Feedback||Tachometer, Incremental Encoder, Hall Effect Sensors|
|Number of Axes (Motors)||1|
|Min Operating Temperature (°C)||0|
|Max Operating Temperature (°C)||75|
|Min Operating Temperature (°F)||32|
|Max Operating Temperature (°F)||167|
|Max Rated Power (W)||1520|
Sample image only. Product may differ