- Buy 5 for $632.00 each and save 5%
- Buy 10 for $599.00 each and save 10%
The DZEANTU-020B080 digital servo drive is designed to drive brushed and brushless servomotors from a compact form factor ideal for embedded applications. This fully digital drive operates in torque, velocity, or position mode and employs Space Vector Modulation (SVM), which results in higher bus voltage utilization and reduced heat dissipation compared to traditional PWM.
The drive can be configured for a variety of external command signals. Commands can also be configured using the drive’s built-in Motion Engine, an internal motion controller used with distributed motion applications. This drive features dedicated and programmable digital and analog inputs and outputs to enhance interfacing with external controllers and devices.
DZEANTU-020B080 drives feature an EtherCAT® interface for network communication using CANopen over EtherCAT (CoE), and USB connectivity for drive configuration and setup.
Drive commissioning is accomplished using DriveWare® 7, available for download at www.a-m-c.com.
All drive and motor parameters are stored in non-volatile memory.
The DZEANTU Series Hardware Installation Manual is available for download at www.a-m-c.com.
The DZEANTU-020B080 also supports ADVANCED Motion Controls’ exclusive ‘DxM’ technology which allows connectivity of up to 3 DZSANTU-020B080 drives to a single DZEANTU- 020B080 on an EtherCAT network.
DZSANTU-020B080 drives receive commands from a DZEANTU-020B080 over a highspeed communication interface, allowing for up to 4 axes of servo drive control from a single EtherCAT connection.
|Vendor||Advanced Motion Controls|
|Short Description||18-80 VDC Input; 10A continuous / 20A peak | 0.8kW Output @ 80 VDC in|
|Min Input Supply Voltage (VDC)||18|
|Max Input Supply Voltage (VDC)||80|
|Max Continuous Output Current (A)||10|
|Max Peak Output Current (A)||20|
|Motor System||Single Phase (Brushed, Voice Coil, Inductive Load), Three Phase (Brushless), Closed Loop Vector|
|Operating Mode||Profile Current, Profile Velocity, Profile Position, Cyclic Synchronous Current, Cyclic Synchronous Velocity, Cyclic Synchronous Position|
|Feedback||Hall Effect Sensors|
|Number of Axes (Motors)||1|
|Min Operating Temperature (°C)||0|
|Max Operating Temperature (°C)||75|
|Min Operating Temperature (°F)||32|
|Max Operating Temperature (°F)||167|
|Max Rated Power (W)||760|
Sample image only. Product may differ