The AZBD10A4 PWM servo drive is designed to drive brushless and brushed DC motors at a high switching frequency. To increase system reliability and to reduce cabling costs, the drive is designed for direct integration into your PCB.
The AZBD10A4 is fully protected against over-voltage, under-voltage, over-current, over-heating, and short-circuits. A single digital output indicates operating status. The drive interfaces with digital controllers that have analog ±10V output. The AZBD10A4 can utilize Hall Sensor feedback, and operates in Duty Cycle (Open Loop) Mode.
This servo drive requires only a single unregulated isolated DC power supply, and is fully RoHS II (Reduction of Hazardous Substances) compliant.
See Part Numbering Information on last page of datasheet or additional ordering options.
The AZ Series Hardware Installation Manual is available for download at www.a-m-c.com.
|Manufacturer||Advanced Motion Controls|
|Product Category||Amplifiers - Analog Type|
|Youtube embed key||X3OC448VSts|
|Min Input Supply Voltage (VDC)||10.00|
|Max Input Supply Voltage (VDC)||36.00|
|Max Continuous Output Current (A)||5.00|
|Max Peak Output Current (A)||10.00|
|Motor System||Single Phase (Brushed, Voice Coil, Inductive Load), Three Phase (Brushless)|
|Operating Mode||Duty Cycle (Open Loop)|
|Feedback||Hall Effect Sensors|
|Configuration||PCB Mounted, OEM Module|
|Min Operating Temperature (°C)||0.00|
|Min Operating Temperature (°F)||32.00|
|Max Operating Temperature (°C)||85.00|
|Max Operating Temperature (°F)||185.00|
|Max Rated Power (W)||171|
Sample image only. Product may differ