STM24QF-3AN

SKU
315280
  • Buy 5 for $543.00 each and save 3%
$559.00

The STM24QF-3AN integrated stepper is a drive+motor unit, fusing a NEMA 24 step motor and a sophisticated, 6.0 A/phase (peak-of-sine) step motor drive into a single device. Power to the drive, located at the rear of the motor, must be supplied by an external DC supply.

The STM24QF-3AN integrated stepper can operate in all of the same control modes as S models, plus the ability to run a Q program stored in non-volatile memory. Q programs are created using Applied Motion’s Q Programmer™ software, which provides powerful commands for motion, I/O, conditional processing, multi-tasking, math functions, and more.

All STM24 integrated steppers are setup and configured using Applied Motion’s ST Configurator™ software.

The STM24QF-3AN comes with 4 digital I/O points, called Flex I/O points, because each point can be individually defined as an input or an output. As inputs, the Flex I/O points accept signals of 5-24 VDC and can be used for connecting pulse & direction signals, end-of-travel limit switches, jog switches, quadrature encoder signals, PLC outputs, sensors, or many other signal types. When defined as digital outputs, the Flex I/O points can be connected to PLC inputs, counters, lights, relays, or other devices. The unit also comes with 1 analog input that accepts 0-5 VDC signals, which can be used for velocity and position control.

The STM24QF-3AN comes with an RS-232 port for programming and serial communications.

Features

More Information
ManufacturerApplied Motion Products
Youtube embed keyTeFBEZ5oNXY
Communication/InterfaceRS-232
Max Holding Torque (mNm)2,401.00
Max Holding Torque oz (in)340.00
Max Length (mm)125.50
Min Operating Temperature (°C)0.00
Min Operating Temperature (°F)32.00
Max Operating Temperature (°C)70.00
Max Operating Temperature (°F)158.00
Shaft Diameter (mm)8.00
Shaft Diameter (in)0.32
Max Input Supply Voltage (VDC)70.00
Motor ConstructionHybrid Stepper
NEMA Frame Size24
Number of Axes1
Operating ModeAnalog Positioning, Encoder Following, Q Programming, Streaming Commands, Modbus RTU
Rotor Inertia (kg-m-s²)8.97E-05
Rotor Inertia (oz-in-s²)1.27E-02
SetupSoftware Setup
Shaft OrientationIn-line,Single-nded
Step Angle (°)1.8
Drive + Motor + Control Unit (RS232)

Sample image only. Product may differ

Product Availability
Lead times can vary. Please contact us for real-time delivery.

Product Attachments

Product Videos