- Buy 5 for $1,810.00 each and save 5%
- Buy 10 for $1,715.00 each and save 10%
The B100A400AC PWM servo drive is designed to drive brushless DC motors at a high switching frequency. A single red/green LED and a single digital output indicate operating status. The drive is fully protected against over-voltage, under voltage, over-current, over-heating and short-circuits across motor, ground and power leads.
Furthermore, the drive can interface with digital controllers or be used stand-alone, and requires a single unregulated AC or DC power supply and a nominal 24 VDC logic supply. Loop gain, current limit, input gain, offset, and ramp can be adjusted using 14-turn potentiometers. The offset adjusting potentiometer can also be used as an on-board input signal for testing purposes.
The drive accepts quadrature encoder inputs or Hall sensor inputs for velocity control.
Features
Vendor | Advanced Motion Controls |
---|---|
Short Description | 200-240 VAC (50/60 Hz, 3ph) Input {optionally 255-373 VDC}; 50A continuous / 100A peak | 16.1kW Output @ 240 VAC in |
Commutation | Trapezoidal |
Min Input Supply Voltage (VAC) | 200 |
Min Input Supply Voltage (VDC) | 255 |
Max Input Supply Voltage (VAC) | 240 |
Max Input Supply Voltage (VDC) | 373 |
Max Continuous Output Current (A) | 50 |
Max Peak Output Current (A) | 100 |
Motor System | Single Phase (Brushed, Voice Coil, Inductive Load), Three Phase (Brushless) |
Operating Mode | Current, Voltage, Duty Cycle, Hall Velocity, Encoder Velocity, IR Comp, Tachometer |
Configuration | Panel Mount |
Drive Architecture | Analog |
Frequency (Hz) | 50,60 |
Phase | Three Phase |
Series | B Series |
Setup | Manual |
Min Operating Temperature (°C) | 0 |
Min Operating Temperature (°F) | 32 |
Max Operating Temperature (°C) | 75 |
Max Operating Temperature (°F) | 167 |
Max Rated Power (W) | 16103 |