- Buy 5 for $186.00 each and save 5%
- Buy 10 for $176.00 each and save 10%
The AZBD10A4IC interface card and PWM servo drive assembly is designed to drive brushless and brushed DC motors at a high switching frequency. The interface card features quick-disconnect connectors.
The AZBD10A4IC is fully protected against over-voltage, under-voltage, over-current, over-heating, and short-circuits. A single digital output indicates operating status. The drive interfaces with digital controllers that have analog ±10V output.
The AZBD10A4IC can utilize Hall Sensor feedback and operates in Duty Cycle (Open Loop) Mode. This servo drive requires only a single unregulated isolated DC power supply, and is fully RoHS II (Reduction of Hazardous Substances) compliant. Easily accessible test points are available for I/O and Feedback monitoring.
See Part Numbering nformation on last page of datasheet for additional ordering options.
The AZ Series Hardware Installation Manual is available for download at www.a-m-c.com.
|Manufacturer||Advanced Motion Controls|
|Product Category||Amplifiers - Analog Type|
|Short Description||10-36 VDC Input, 5 A Cont. (10 Peak)|
|Min Input Supply Voltage (VDC)||10|
|Max Input Supply Voltage (VDC)||36|
|Max Continuous Output Current (A)||5|
|Max Peak Output Current (A)||10|
|Motor System||Single Phase (Brushed, Voice Coil, Inductive Load), Three Phase (Brushless)|
|Operating Mode||Duty Cycle (Open Loop)|
|Feedback||Hall Effect Sensors|
|Configuration||PCB Mounted, OEM Module|
|Series||AZ Series,vendor=Advanced Motion Controls|
|Min Operating Temperature (°C)||0|
|Min Operating Temperature (°F)||32|
|Max Operating Temperature (°C)||85|
|Max Operating Temperature (°F)||185|
|Max Rated Power (W)||171|
Sample image only. Product may differ