AB100C200 servo amplifiers are designed to drive brushless DC motors at a high switching frequency. It is fully protected against over-voltage, over-current, over-heating, under-voltage and short-circuits.
This model interfaces with digital controllers or can be used as a stand-alone drive and requires only a single unregulated DC power supply or battery. A single red/green LED and a single digital output indicate operating status.
Loop gain, current limit, input gain, and offset can be adjusted using 14-turn potentiometers. The offset adjusting potentiometer can also be used as an on-board input signal for testing purposes. It will accept tachometer input, quadrature encoder inputs, or Hall sensor inputs for velocity control.
Features
Manufacturer | Advanced Motion Controls |
---|---|
Min Input Supply Voltage (VDC) | 40 |
Max Input Supply Voltage (VDC) | 175 |
Motor System | Single Phase (Brushed, Voice Coil, Inductive Load), Three Phase (Brushless) |
Operating Mode | Current, Duty Cycle, Duty Cycle (Open Loop), Hall Velocity, IR Compensation, Velocity, Voltage |
Configuration | Vehicle Mount |
Min Operating Temperature (°C) | 0 |
Min Operating Temperature (°F) | 32 |
Max Operating Temperature (°C) | 75 |
Max Operating Temperature (°F) | 167 |
Number of Axes | 1 |
Commutation | Trapezoidal |
Drive Architecture | Analog |
Max Rated Power (W) | 16625 |
Max Continuous Output Current (A) | 100 |
Max Peak Output Current (A) | 100 |
Setup | Manual |
Product Category | Motor Controllers for Electric Vehicles |

Sample image only. Product may differ